Low-pressure glue gun, special for airplane model, field glue gun, T plug and XT60 plugs are available, heat conduction is fast and the glue is smooth and continuous.

Note on leakage of glue gun:
1. Because the glue is squeezed out by pushing the trigger to increase the internal pressure, when the glue is just finished, the internal pressure is not released completely. Because of inertia, even if you don’t use the glue gun at this time, the glue will leak out a little until the internal pressure is released completely;
2. As for the amount of leakage after gluing, it is related to the grade of glue gun, power and melting point of glue strip, as well as the force and time of pulling the plate machine. Therefore, we should release the plate machine in advance according to the amount of glue that may continue to flow out, and select the appropriate force to buckle the plate machine according to the amount of glue needed to achieve the purpose of glue saving;
3. When the glue is not applied for a long time, the glue will melt back slightly due to the heat, and the volume inside the gun chamber will increase slightly, so the glue may flow out a little bit.
4. Methods of saving glue:
A: When the amount of glue used at a time is not very large, it is lighter to use the plate machine. When the amount of glue used is large, it is heavier,
B: With high-grade glue gun, it can save energy and glue.