Radiolink Wireless Trainer Cable Cord 7.4V-16V Input Support PPM Signal Transmitter for AT9 AT9S AT10II T8FB Remote Controller
Radiolink Wireless Trainer Cable Cord 7.4V-16V Input Support PPM Signal Transmitter for AT9 AT9S AT10II T8FB Remote Controller
Thank you for choosing Radiolink wireless trainer cable This cable is compatible with all the transmitters that support PPM signals and PPM receivers.
Suggestion:In order to fully enjoy the benefits of this cable, please read the introduction carefully and set up the device as described below.
If you found any problems during the operation process, please refer to the manual.
Specification:
Brand: Radiolink
Item: Remote Wireless Trainer Cable
Fit for: compatible with all the transmitters support PPM signal
Compatible with: AT9 AT9S AT10II T8FB Remote Controller
Input voltage: 5V-15V(support 8pcs 1.2V AA battery or 2S-3S LiPo battery)
Output voltage: 5V
Current: 200mA
(Attention: since the output voltage of trainer cable is limited to 5V and the power is limited to 200mA, it just support power for receiver, cannot power for servo or image transmission or any other equipment)
Notes:
(1) Make sure your plane is power off.
(2) Make sure the Teacher transmitter and Student transmitter setup the same Model Type.
(3) Make sure the Teacher transmitter and Student transmitter have not connecting other planes.
Radiolink Wireless Trainer Cable Cord 7.4V-16V Input Support PPM Signal Transmitter for AT9 AT9S AT10II T8FB Remote Controller X 1
Related products
-
Wire Connector
APM2.5/2.6 3Dr Digital signal lines connecting line
Reviews
There are no reviews yet.