Categories

Payment

  • Ebay

Shipment

  • Hongkong post
  • EMS
  • FEDEX

Transmitter & Receiver > Product details

Matek MATEKSYS ELRS-R24-P6 R24-P6 EXPRESSLRS 2.4G 6CH PWM Receiver ExpressLRS 3.0 VBAT Voltage Sense for RC Airplane Fixed-Wing

Matek MATEKSYS ELRS-R24-P6 R24-P6 EXPRESSLRS 2.4G 6CH PWM Receiver ExpressLRS 3.0 VBAT Voltage Sense for RC Airplane Fixed-Wing
Part No.: ELRS-R24-P6
Manufacturer: Matek

Send to a friend

Your name:
Your e-mail:
Recipient's email:

Features

Matek MATEKSYS ELRS-R24-P6 R24-P6 EXPRESSLRS 2.4G 6CH PWM Receiver ExpressLRS 3.0 VBAT Voltage Sense for RC Airplane Fixed-Wing

Product Details

Specifications
- ESP8285, SX1281
- Antenna connector: IPEX MHF 1
- 6x PWM outputs
- Support 2~8S VBat voltage sense
- RF Frequency: 2.4GHz (2400~2480MHz)
- Telemetry power: 12dbm
- Receiver output protocol: PWM
- Input voltage: 4~9V DC @ “+” pad
- Voltage sense: 34V Max. @ “VBat” pad
- Power dissipation:  45mA(binding), 85mA(wifi mode)
- PCB size: 20mm x 18mm
- Weight: 2g w/ antenna

Firmwares
- ExpressLRS 3.0 or newer,   DIY 2.4 GHz / DIY 2400 RX PWMP EX
- ExpressLRS wiki for PWM receiver, Click HERE
- Make sure Receiver and TX module both are running ExpressLRS 3.0 or newer
——————————————————
- Receiver has ExpressLRS 3.0 preloaded with binding phrase “123456”,  the Receiver will never enter binding mode if using the traditional binding procedure.
- You need to reflash it with your binding phrase OR go into WebUI to set your binding phrase.

Flashing via Wifi
- Disconnect ESC and servos from receiver first.
- Power on receiver by 5V source. Receiver’s LED(Red) will blink slow at first, and after 20s, it should blink fast indicating it’s on Wifi Hotspot Mode.
- More detailed steps,  pls refer this page.
- Target: DIY 2.4 GHz / DIY 2400 RX PWMP EX

Flashing via UART
1. Disconnect ESC and servos from receiver first.
2. Wire the receiver into the USB-TTL adapter, with TX on receiver connected to the Rx on the USB-TTL, and RX on receiver connected to the Tx of the USB-TTL. Wire 5V and GND of the USB-TTL to 5V and GND of the Receiver.
3. Press the boot button while powering on the receiver, then release – the Red LED on receiver should now be solid.
4. Select the target DIY 2.4 GHz / DIY 2400 RX PWMP EX  and  “UART” for Flashing Method,  set your bind phrase and Firmware Options and once done, click on Build and Flash.

Item Packing

1x ELRS-R24-P6
1x IPEX MHF1 Antennas. 15cm
Dupont 2.54 pins  (Board is shipped unsoldered)

Detailed Images




Recommended products list